Resource · Pittsburgh, PA

Western Pennsylvania radon by county and community

The EPA's Pennsylvania radon zone map, published in 1993, places Allegheny, Butler, and Westmoreland counties in Zone 1, its highest-potential tier. The map was built to prioritize programs, not to describe houses, and the EPA itself says it should not be used to decide whether a particular home needs a test.

The measured record is the better guide, and in Pennsylvania it is unusually deep. The PA DEP reports that about 40 percent of homes tested statewide are at or above the EPA action level of 4 pCi/L, and that elevated homes have been found in all 67 counties. A USGS analysis of DEP results from 1990 through 2007 found 39 percent at or above 4, and an AARST summary of 940,627 results reported to the DEP from 2010 through 2020 found 35 percent. The Allegheny County Health Department repeats the "up to 40 percent" figure for county residents.

We have not reproduced ZIP-level averages here, because a small sample in one ZIP code can mislead more than it informs. The community rows instead describe the housing that shapes how a test and a system should be planned in each place.

County or communityCounty and EPA mapWhat the data and the housing say
Allegheny CountyZone 1Pennsylvanian-age cyclic shales and limestones of the Appalachian Plateau underlie the county. Housing is among the oldest of any US metro, with heavy pre-1940 stock in the city and inner boroughs.
Butler CountyZone 1Same plateau geology. Cranberry Township adds the newest housing in the region, much of it with builder radon rough-ins that still need a test after move-in.
Westmoreland CountyZone 1Pre-war county-seat housing in Greensburg and hillside custom homes around Murrysville, some on private wells at the outer edges.
Washington CountyMeasured: elevated homes foundThe PA DEP has found homes above the EPA action level in all 67 counties, Washington included. Measured statewide data, about 40 percent of tested homes at or above 4 pCi/L, is the reason to test here.
Pennsylvania, DEP figureAbout 40% at or above 4 pCi/LShare of homes tested statewide, as reported by the PA DEP.
Pennsylvania, 1990-200739% at or above 4 pCi/LUSGS analysis of DEP test data, Scientific Investigations Report 2013-5143.
Pennsylvania, 2010-202035% of 940,627 resultsAARST 2024 summary of results reported to the DEP.
Pittsburgh (city)Allegheny / Zone 1Stone and early block foundations, sectioned floors, coal cellars, and tall frame houses with strong winter stack effect.
Mt. LebanonAllegheny / Zone 11920s and 1930s brick colonials and Tudors on compact lots. Coal rooms under porches and close side yards shape the routing.
Bethel ParkAllegheny / Zone 1Postwar block basements, split-levels, and walkouts on rolling ground.
Upper St. ClairAllegheny / Zone 11950s to 1980s homes, most with finished lower levels and sumps on footer drains.
MonroevilleAllegheny / Zone 1Ranches and split-levels on cut-and-fill lots, where fill and native soil pass suction differently.
Penn HillsAllegheny / Zone 1Large postwar inventory, many with garages under the downhill side; older river-valley sections with stone foundations.
Ross TownshipAllegheny / Zone 1Postwar North Hills houses with frequent additions over crawl spaces.
Shaler TownshipAllegheny / Zone 1Valley houses with French drains and perimeter channels; postwar hillside plans above.
Moon and Robinson townshipsAllegheny / Zone 1Postwar streets plus 1990s and newer subdivisions, some with passive radon pipes.
Wexford (Pine Township area)Allegheny / Zone 1Large post-1995 homes with deep poured basements; big footprints sometimes need two suction points.
Cranberry TownshipButler / Zone 1Newest stock in the region. Test after move-in; activate a passive pipe with a fan if the result calls for it.
MurrysvilleWestmoreland / Zone 1Multi-level hillside homes and wooded lots, some on private wells.
GreensburgWestmoreland / Zone 1Pre-war brick over stone foundations near downtown; expect a heavier sealing scope.
WashingtonWashington CountyOlder housing near downtown and the college. Measured statewide data, not the map label, is the reason to test.

The next step is the same in every row. Test the lowest level people actually use, with the house closed, during the heating season if you can. A result of 4 pCi/L or more means fix the home; between 2 and 4, the EPA recommends considering it.

For what a fix costs on each foundation type, see the pricing guide. For why the three statewide percentages differ and what they share, read the 40, 39, and 35 percent explainer.

Ready to get started?

Stone foundations, hillside walkouts, coal cellars, and new Cranberry builds each get a design, not a template. Mon-Sat 8am-7pm.

Call (412) 213-6297Text us

Prefer to text? Open your texting app