Radon Mitigation Systems in Washington
Active soil depressurization built around the foundation in front of you: a hand-laid stone basement from the 1920s, a block-wall walkout cut into a hillside, a coal cellar turned laundry room, or a poured basement in a newer Cranberry plan. Every install is performed by a Pennsylvania DEP-certified mitigation professional working to the ANSI/AARST SGM-SF-2023 standard, and the post-install verification report carries the certification number Pennsylvania has required on radon reports since 1988. Washington sits within our service area for Greater Pittsburgh and Western Pennsylvania, with same-week scheduling typical for routine jobs.
Typical pricing in Washington
$1,100-$2,600
Pricing varies by job specifics. Free phone or on-site quotes; fixed pricing once the technician has assessed the job.
Radon Mitigation Systems in Washington: a county seat of pre-war neighborhoods and college-town streets foundations and Appalachian Plateau shale geology
Washington's housing leans old: pre-war brick and frame houses around the downtown and the college, over stone foundations with the same coal-cellar conversions and sectioned floors seen across the region. What the numbers say matters more than any map shading here: the PA DEP reports that about 40 percent of Pennsylvania homes tested are at or above 4 pCi/L, and homes above the EPA action level have been found in all 67 counties, Washington County included. The only way to place one specific house inside or outside that statistic is a test in its own lowest lived-in level. Washington sits on the uranium-bearing Pennsylvanian shales and limestones of the Appalachian Plateau, where state tests have found radon above the action level in every county. Washington County is EPA Zone 2, a moderate rating, but measured results there still come back above the action level often enough that testing is the only way to know.
Washington's older houses around downtown and the college sit on stone with coal-cellar conversions and sectioned floors, so an install often includes sealing the old chute wall, closing gaps in the stone, and placing suction where floor sections meet. Postwar houses on the city's outer streets have block basements and take a more standard single-point install. Narrow lots near downtown often push the stack to the rear.
Pennsylvania mitigation is done by DEP-certified firms under 25 Pa. Code chapter 240, to ANSI/AARST SGM-SF-2023, the consensus standard for existing homes. The Pennsylvania DEP's Radon Division oversees radon program compliance for Washington, and Pennsylvania has required DEP certification for radon testing and mitigation since 1988 (the Radon Certification Act, 63 P.S. 2001 to 2014), with the certification number printed on every report.
- County
- Washington, PA
- Geology
- Pennsylvanian cyclic shale and limestone
- EPA action level
- 4.0 pCi/L on long-term average
- Service category
- Mitigation