A new hum or whine usually means bearings wearing out, a rattle points to a loose mount or coupling, and gurgling means condensation pooling in the pipe. None is dangerous, but a fan announcing its age should be replaced before it quits silently.
More detail
Condensation is the Pittsburgh classic. Soil gas leaves the ground warm and damp, and when the stack runs up a cold exterior wall or through an unheated attic in January, water condenses inside the pipe. A correctly built system slopes everything so that water drains back to the soil below; a sag in a horizontal run collects it instead, and the fan churns the puddle audibly with every cycle of wind. Bearing wear sounds different, a pitch that rises over weeks, and it ends the same way every time, so a scheduled swap beats an unscheduled failure discovered at the next retest. Rattles usually live in the rubber couplings that isolate fan vibration from pipe and framing, which loosen over years and tighten in minutes. A fan mounted somewhere the current standard would not allow, in the basement itself for instance on an old install, will always be the loudest option and is worth relocating when it comes due. The repair service prices fan swaps and the system check FAQ covers what to verify after any fix.